All news
- Details
The installation was executed by the hoisting installation subdivision SMU-2 of JSC CONCERN TITAN-2. This subdivision is responsible for the assembly of all the cranes at LNPP-2 power units construction site.
The works on the polar crane in the reactor building took several months. The load trolley and maintenance portal of the crane were preassembled in the special area close to the reactor building. The weight of these assemblies was 102 and 10 tons respectively.
The specific design was made to move these components with Liebherr LR11350 crawler crane into the reactor building. Open-top method was used to move the components through the roof, which has not yet been closed with the dome. Two months earlier SMU-2 specialists performed the complicated installation of the polar crane beam weighing over 200 tons and 40 meters long. The load trolley and the maintenance portal were installed on this very beam.
Now the specialists proceed to the final assembly and commissioning works. After the reactor building is covered with the dome, the installation of the crane power supply system will commence.
Note:
Titan-2 Holding is the largest in the North-West group of companies, constructing the most important nuclear industry and power facilities. The company performs a full range of construction and installation works from engineering to commissioning.
Titan-2 Holding is the general contractor for the construction of the Leningrad NPP-2 power units. The Holding Companies perform all the civil, installation, and electrical works at a construction site. The works are carried out in the reactor, turbine, power supply, water supply, heat cogeneration buildings and other power unit structures.
The Holding is the main contractor for the construction of the Hanhikivi-1 NPP in Finland.
- Details
They covered 2000 kilometers in 5 days.
- Details
The specialists of JSC MSU-90 and JSC CONCERN TITAN-2 performed the installation.
- Details
The event took place in the Finnish city of Oulu, the capital of Northern Ostrobothnia, where the Hanhikivi-1 NPP is under construction based on the Russian design.
- Details
The work is carried out using in-house resources of JSC CONCERN TITAN-2.
- Details
The employees with the best results will represent the company in the final that will take place in Rostov-on-Don in August.
- Details
The height of the structure reached 105 meters.
- Details
JSC MSU-90 is carrying out the work. Each heat exchanger assembly weighs approx. 7 tons.
- Details
Learning about practical implementation of the NPP with VVER-1200 was the main goal of the visit.